Imagine Technologies Fully Automatic Water Level Controller For Corporation Water Supply line Wired Sensor Security System

Description

In This Device You Will Get 3 Sensor For Upper Tank And one inline sensor for water Detection . Connect All Sensor As Per Given Diagram (G, R/R1, G1,B1) The Center Sensor (R) And (R1) Are Common. Now Do Wiring For Inline Sensor . There is two wire in inline sensor one wire add to (G) and one add to (R) as per diagram. The inline sensor have 1 minute water detection timer. so it can Pumping water easily from Supply line . This Model Will Automatically Switch ON Motor For 1 Minute If Inline Sensor Detect Water. After If Water Coming Continue Then It Will Fill Upper Tank And Automatically Switch OFF When Up Tank Full .If Water Not Coming Within 1 Min It Will Off Motor As Dry Run Protection. In Overhead Tank Install (R1) In Bottom Same As Above . Then( G1) Sensor As Your Low Level Sensor (That Means Motor Start Sensor) And Install (B1)Sensor As High Level Sensor For Overhead Tank (It Is Motor Cut Off Sensor When Tank Is Full, Motor Is Off). You Can Connect This All Sensor Through 1 Mm 3 Core Wire. Sensor Should Not Float In Water. Make It Steady At One Place That You Desired It. And Another Side Two Input Terminal And Two Output Terminal . Connect Phase And Neutral To Input Terminal (230v Ac Power )And Connect Motor Phase And Neutral To Output Power . Long Life. Easy To Install. Advanced Embedded Technology. Features: 1.Elegant Looks 2.No Man power Required To operate as Fully Automatic . 3.Avoid Overflow & Dry Running Longer Life No Mechanical System 4.Saves Electricity 5.Compact Metal (Virgin) Housing 6. Control Underground Tank To Overhead Tank Specifications: 1.Operating voltage 220-250 volts AC. 2. Frequency 50 Hz. 3. Load capacity each switch (2 HP)